[Conversion 8bit / 16bit - tiny bug]

sometimes tiredness takes away your ability to think logically in solving trivial problems. Thank you for your help

[Conversion 8bit / 16bit - tiny bug]

 

after changing the units to 8 bit, the minimum and maximum values are the same

[development proposal]

I suggest that under each field where png files are inserted, you should provide short information about the recommended file resolution so that you do not have to waste time looking for this information in the documentation

[The color is not taken from the color filter]

- I took measurements to get the correct values

- I put the values into the filters tab
- I assigned filters to the color wheel
- colors were not assigned from filters to values in the dmx table

 

[Little problem with conversion GDTF -> MA2]

Hi. maybe it is not good place to publicate it, but I will try...

I encountered two problems with converting GDTF to MA2.

 

For one fixture I created, the first is that the main instance is given class="none", although it should be "headmover", which indicates the inability to introduce pan and tilt offset as well as pan and tilt invert.

The second problem is uploading the fixture to ma2 share. The corrected library exported from ma2 can only be uploaded as an xml file. It is not possible to upload the full library which is a zip package (gobos inside).

[problem when copying dmx mode]

[problem when copying dmx mode]

Hi, 

when copying mods, I encountered the problem of not copying Initial Channel Function values. this means that if in some base mode I set the starting channels, after copying in a new mode, the starting channels always start from the beginning, not in the predetermined order

[Publication by manufacture]

Hi, I found another problem. publishing a fixture from manufacture but specified as a different brand causes these fixturs to appear on the manufacturer's website. This causes the files published on the website to appear unwanted links to devices. thanks in advance.

[Problem with POLISH keybord at manufacture website]

Hi, from the manufacture level you can create your own manufacturer page. This is a very interesting possibility. However, when adding a post in the native language, and in my case it is Polish, it is not possible to publish it. After removing the typically Polish characters ą, ć ó, ł, Ż, ź, publication was possible.